Take control of your product’s performance.

Do Your Own Testing

Testing isn’t just for million dollar companies. No matter how big or small your data acquisition and analysis requirements may be, DYOT has the solution to bring you state-of-the-art test equipment and world-class applied industry knowledge.

Acquiring accurate test data can be challenging. With over 15 years of testing experience in both corporate environments and in the field, we can help you navigate the entire process with confidence.

Our expertise is measuring high-speed torque and horsepower data for your application. On the track, in the dirt, on the water, or at your facility – wherever you need to measure it – DYOT has you covered!

How It Works

Full-Service Approach

Let us do the dirty work. We have the experts and the equipment to provide you turn-key data. Just tell us what you need measured, and we will use our commercial-grade test equipment to get you the measurements you need and provide you with expert analysis and reporting. Beyond that, we can help with any further development testing to meet your requirements.

Hands-On Approach

If you want to perform your own testing, we will share our expertise and show you the tools and methods you need to acquire the required data. We’ll take care of the setup and oversee the data acquisition & analysis, allowing you to be more involved with the process and confident that the proper system is in place to deliver the testing results you need.

Static Torque/Low Cycle Fatigue Testing

Understanding the static torsional limit (how much it twists before it breaks) of your product is the first step in designing a better system. When you fully understand the potential weaknesses in the design, you can optimize them out. This results in better, stronger and more cost efficient parts.

DYOT’s static torque tester accommodates parts up to 15 inches in diameter and 7ft in length. It can apply static or low-cycle fatigue loads up to 8,300 ft lbs and 55 degrees of twist. We can utilize existing fixturing, or design and build custom fixtures as needed to test your parts.

Design modifications to existing parts, due to supplier changes and requirements, can also be tested.

Commercial and Industrial Testing

RYTEC

High Performance Doors
– CASE STUDY –

The test data collected proves to be invaluable for refining future product designs.

VEhicle Instrumentation in the Field or at Your Facility

We can help you instrument your vehicle for torque measurement in-house and synchronize it with CAN data and most other sensors to measure main driveshaft data, per-axle data, or any other shaft configuration.

Whether you’re looking to test two or four-wheel drive, we can show you how much torque you are putting down to the ground. Torque data is also perfect for helping tune differentials, clutches, trans brakes or anti-lag systems.